Steel J Bracket Shelf Installation Instructions

These instructions cover our thick oak and mahogany shelves with black steel J brackets. The brackets lag bolt into wall studs and the shelf rests in the J.

Prefer a printout? Download the PDF version of these instructions.

What is in the box

• Shelf
• Steel J brackets
• Lag bolts

Tools you need

• Drill, with a 3/16 inch bit
• Level
• Pencil
• Stud finder
• Wrench or socket

Installation steps

1. Choose the shelf location. Decide where the shelf goes. Using a level, draw a straight horizontal line where the top edge of the shelf will sit.
2. Mark the studs. Use a stud finder to locate the studs along your line and mark them. Studs are usually 16 inches apart. Attach the shelf to at least two studs for the best support.
3. Drill pilot holes. With the 3/16 inch bit, drill into the studs along your line. Place the holes a few inches in from each end of the shelf.
4. Attach the brackets. Tighten the lag bolts with a wrench or socket. Do not overtighten.
5. Set the shelf. Place the wood shelf on top of the mounted brackets.

Other wall types

• No studs where you need them? We recommend toggle bolts for a secure mount.
• Tile. Pre-drill through the tile with a 5/16 inch masonry (diamond) bit, then drill into the studs behind the tile with the 3/16 inch bit, and mount the brackets with the provided lag bolts.
• Brick or concrete. Drill a 1/4 inch hole and secure the brackets with masonry anchors.

Other installation guides

Guides for our other products: 3 to 8 inch deep floating shelves, thick floating shelves, corner shelves, small shelves and propagation shelves, shelves with wood brackets, deep shelves with L brackets, picture ledge, coat racks, disc hat rack, subway clock, corner shelf with reversible bracket. If anything is unclear, email support@nookwoodworking.com and we will walk you through it.